What does wallpaper or linoleum do next? What should I do first - wallpaper or lay the floor? Tools required for installation

Laying linoleum does not require professional skills or special knowledge; you can do it yourself.

In this article we will give basic tips that will help you properly prepare for self-installation: how to calculate the required amount of material, how to prepare the room and base, what tools to purchase.

Calculation of linoleum

It is necessary to measure the entire floor area and draw up a floor plan. Walls may be uneven, so you should take measurements at different points, taking into account niches and doorways so as not to patch them in pieces later. Put all dimensions on the diagram. Calculate the length of the coating based on the width of the canvas. If possible, it is better to lay linoleum in one sheet without joints. The store sells rolls 1.5-4 m wide.

Buy linoleum with a margin, taking into account the overlap of 5-10 cm on the walls. If you cannot avoid joints, try to calculate the material in such a way that there are minimal connections between the panels.

Preparing the base for installation


Linoleum should be laid on a well-leveled base. There should be no dust or crumbs on the floor. This is especially critical for thin material - any pebble will visually manifest itself after installation, and during use, abrasion or cracks may appear in this place.

The concrete base must be leveled with a special compound and dried properly. Lay linoleum only after complete drying.

Check the wooden floor for the presence of fasteners (screws and nails). If any are found, remove them or drown them in boards. To level the floor, lay sheets of plywood or OSB, sand the joints and putty. If linoleum is laid directly on a wooden floor, the coating will repeat the unevenness of the boards and will look unsightly.

When should you lay linoleum: after wallpapering or before?

If you lay the covering before wallpapering, it can be damaged later by stepladder legs or tools. Special care is required here. If you vouch for it, then it is still better to install it before pasting, since rolling out and cutting the roll in a room with freshly pasted walls is very problematic - there is a risk of damaging or staining the wallpaper when adjusting and trimming the linoleum.

Tools required for installation

  • Metal ruler
  • Roulette
  • Pencil
  • Double sided tape
  • Knife with replaceable blades
  • Adhesive for welding joints
  • Glue or mastic, notched trowel (if you are going to glue the linoleum to the base)

Preparing the premises

  • The room temperature must be at least 18°C.
  • Clear the room of unnecessary items and remove all furniture.
  • Remove baseboards.
  • Remove old flooring.
  • Eliminate base defects.
  • Lay sheets of plywood or OSB on the wooden floor.
  • Level and prime the concrete base.
  • Plaster the joints between the floor and walls. If there are large cracks there, foam them first. After the foam has dried, cut off the remains and putty.

The floor is ready, you can start

We bought linoleum, too, and all the bells and whistles that come with it, but the question arose: WHAT SHOULD COME FIRST? WALLPAPER OR LINOLEUM??? WHAT TO DO???

Answers

Wallpaper if there is a room with skirting boards
if not then linoleum

First, the walls :) which means wallpaper with bells and whistles :) patience to you in this difficult matter :)

You do this: roll out the linoleum and trim it, then roll it up again, glue the wallpaper and unroll the linoleum again. And you won’t have to wash off the glue and you won’t tear the wallpaper when unrolling a large piece of linoleum.

Lay down the linoleum first, then the wallpaper, if it’s the other way around, you’ll tear up all the wallpaper anyway... Damn, washing off the glue is, of course, a super task that requires a lot of effort... :)

Repairs are always done from top to bottom. This means wallpaper, then linoleum.

First they make the floor. Then wallpaper. You cover the floor, put a film on top of the linoleum bed (so as not to get it dirty), then glue the wallpaper, and at the end you fill (or glue) the baseboards.
I have been doing repairs for many years.

Lay down linoleum, then roll out the wallpaper on clean linoleum!

The wallpaper is glued last. When everything is already painted and laid.

First the walls

If the wallpaper is to be painted, then first glue the wallpaper and paint it once, then lay the linoleum, cut it, let it sit for 2 days, cut it again, glue the linoleum (it’s up to you to glue it or not), nail the baseboards and paint the wallpaper a second time .

Tag:

What comes first is wallpaper or linoleum What comes first is linoleum or wallpaper

Stretch ceilings have recently gained more and more fans. This is facilitated by their beautiful appearance, long service life, ease of maintenance and ease of installation.

Such stretch ceilings are made from thin polyvinyl chloride film or fabric stretched over a frame.

The surface turns out perfectly smooth; it does not need to be refreshed or tinted, as it will look like new for many years. The only drawback of a stretch ceiling is that it will take up at least four centimeters of the height of the room.

The color of the stretch fabric depends on the customer’s wishes and is selected to match the interior in which the room is decorated. The ceiling can be plain, with photographs, colored patterns, pictures, imitation of any material is possible. It is easy to integrate LED ceiling spotlights into this suspended ceiling.

Installation Methods

There are two ways to install suspended ceilings:

  • Harpoon. The room is carefully measured and according to these measurements a canvas of the required size is made. The installers attach the frame, that is, a baguette, to the walls. The film is heated with a heat gun and stretched along the perimeter over the entire ceiling surface and secured in baguettes with special latches.

  • The harpoonless method involves stretching and fastening the heated film in the same way as the fabric is stretched on a hoop. This method is cheaper and faster, since preliminary dimensions and cutting of the canvas are not required. But sometimes the film sagging occurs, so in this case, thicker fabric is often used. It does not need to be heated, but it is possible to paint or paint it yourself.

Sequence of work

Experts insist on a certain order of work during the repair process. First you need to do all the dirty work: remove old coverings, level and groove the walls. Then the latter are puttied and left. Now you can prepare the subfloor for laying the floor covering - screed, etc.

Next, they install a suspended ceiling, glue wallpaper, and only then lay laminate or carpet. Installing a stretch ceiling is a clean job, but craftsmen can scratch the floor, so it should be done last.

How to make suspended ceilings with your own hands, watch the video:

During the repair, questions arise that relate to the order of performing certain tasks. The processes are done carefully, using natural technology. Therefore, you need to know what is used first: wallpaper or linoleum.

First of all, first of all...

When it comes to wallpapering during renovation, many questions immediately arise. It is especially important to decide what will be done first: wall cladding or flooring. The sequence of processes leaves builders who are just starting out and residents confused. Therefore, it is necessary to determine what to do in this situation.

Finishing option

The following parameters are taken into account:

  • amount of dust and debris during work;
  • volume of the process being carried out;
  • repair technique.

Not all construction masters are unanimous in favor of a specific order. At the same time, a large number of workers still prefer to stick first wallpaper. And only after that, with peace of mind, they lay down linoleum or other material for finishing the floor.

Why do they tend to take this order? It's simple. Pasting walls requires the use of the entire plane of the room. It is not possible to fix the paper itself on the wall surface without wallpaper glue, so specialized mixtures are used. Applying them vertically will not work because of the inconvenience, so you have to roll out the roll on the floor, which usually leads to damage to the new coating.

Sequence of work

There are 2 styling technologies. To understand what is done first: glue wallpaper or creeps linoleum, let's consider two options.

Linoleum installation

Method 1

Work can be done when the floor base is ready for the installation process. To do this, prepare the surface - make it smooth and clean. The fencing structures are plastered and leveled. The next sequence of work looks like this:

  • do wallpaper;
  • then begin the process of installing linoleum;
  • We weld seams at the junctions of pieces of flooring, if complete material was not used;
  • mark the baseboard.

Method 2

This option is suitable for those cases when dirty work has not yet been carried out, and the planes of the floor and walls are not prepared for work. The sequence of the process is as follows:

  • we level the walls using plaster or putty;
  • priming walls and partitions;
  • before going to bed linoleum, prepare the floor - fill it with concrete or self-leveling mixture (as an alternative solution, use plywood or fiberboard);
  • cut the material into pieces;

Wallpapering

Main! When cutting linoleum, be sure to leave a gap of 0.5 mm at the joining points of the material and next to the walls.

  • glue the wall trim;
  • using glue, mark linoleum;
  • The final stage is welding the seams of the floor covering and attaching the baseboard.

Under any circumstances, all construction work is carried out from top to bottom.

WALLPAPER. Pasting the First Canvases on the Wall.


You have started a major renovation and are drawing up a plan for future work, but you just can’t decide on the sequence, what comes first - wallpaper or linoleum? It is impossible to find a definite answer to this question, since a lot of nuances arise during repairs. If you first lay linoleum and strengthen the baseboard, will the top layer of material be damaged by toxic wallpaper glue, especially if the wallpaper is non-woven? But if you glue wallpaper and then lay the flooring, will you damage the walls by placing linoleum in a small room?

To accurately determine for yourself what comes first - wallpaper or linoleum, first of all pay attention to the complexity of the work being carried out. Typically, the more labor-intensive work is completed first.

The sequence can also be determined if we rely on whether the rough work has been done.

Option 1

If the base of the floor is ready for installation, has a smooth and clean surface, the walls are also plastered and leveled, the answer to the question “what comes first - wallpaper or linoleum” is obvious: experts advise gluing the wallpaper first.

Sequence of work:

  • Paste the wallpaper.
  • Glue the linoleum.
  • Weld the linoleum seams.
  • Attach the baseboard.

Option 2

If the rough work is not carried out, the bases of the floor and walls are not prepared.

Sequence of work:

  • Level the walls using plaster or putty.
  • Prime the walls.
  • Prepare the floor - make a cement screed, lay plywood or fiberboard if necessary.
  • Cut the linoleum - cut it at the walls, leaving a gap of 0.5 mm at the joints.
  • Glue the linoleum.
  • Paste the wallpaper.
  • Weld the joints and attach the baseboard.
Loading...Loading...